HYDRODYNAMIC ANALYSIS OF FIN STABILIZER FOR FREEFLOATING SEMI SWATH

Authors

  • Arifah Ali School of Mechanical Engineering, Universiti Teknologi Malaysia, 81200 Skudai, Johor Bahru, Johor
  • Bong Kai Lun School of Mechanical Engineering, Universiti Teknologi Malaysia, 81200 Skudai, Johor Bahru, Johor

DOI:

https://doi.org/10.11113/jtse.v8.150

Keywords:

Flow-3D, Semi-SWATH, fin stabilizer

Abstract

Advance Marine Vessel, Semi-SWATH is a potential vessel design for offshore operation. Fin stabilizer is an essential component for Semi-SWATH to handle the instability in rough weather. Therefore, the best design for the fin stabilizer should be chosen to ensure good Semi SWATH performance including optimum powering and seakeeping criteria in various conditions. However, seakeeping analysis of semi-SWATH in free floating condition is less available than in high-speed condition. The hydrodynamic analysis of the fin stabilizer on Semi SWATH vessel is very essential in free-floating condition to maximize the function of fins on Semi SWATH. In this paper, the hydrodynamic analysis of fin stabilizer for free floating semi-SWATH is analysed at zero degrees fin angle. In this research, the hydrodynamic of semi-SWATH is obtaining from CFD simulation. Analysis results indicate that reduction of pitch angle for free floating up until 9.8% is obtained with fin stabilizer for wave length ratio 4.2.

References

Papanikolaou, A. (2005). Review of advanced marine vehicles concepts. In Proceedings of the Seventh International Symposium on High speed marine vehicles (HSMV 2005), Naples, Italy (pp. 21-23).

Liang Yun. Alan Bliault. (2012). High Performance Marine Vessels. Springer, Boston, MA. ISBN 978-1-4614-0868-0.

Lang, T. G., Hightower, J. D., and Strickland, A. T., (1974), “Design and Development of the 190-Ton Stable Semi-Submerged Platform (SSP)”, Journal of Basic Engineering, Trans. ASME, November 1974.

Kennell, C. (1985, April). SWATH ship design trend. In London: RINA International Conference on SWATH Ship and Advanced Multi-Hull Vessel, London, UK.

Holloway, D. S., (2003). “Experimental Seakeeping of Semi-SWATH ship at High Froude Number”, University of Tasmania, Australia, Trans RINA, pp. 15-30.

Segundo, E., et al., (2000). “Smoothing Fast Ferry Vertical Motions: A Simulation environment For the Control Analysis”, Dept. Arquitecture de Computadores y Automatica, Facultad de Ciencias Fisicas Universidad Complutense de Madrid, 28040 Madrid, Spain.

Qian, P., Yi, H., & Li, Y. (2015). Numerical and experimental studies on hydrodynamic performance of a small-waterplane-area-twin-hull (SWATH) vehicle with inclined struts. Ocean engineering, 96, 181-191.

Frohlich, I. M., Grabert, D. I. R., Postsdam, S. V., Brink, D. I. K. E., & Schiffbau-Versuchsanstalt, H. Investigations to Improve Seakeeping Behaviour of a High Speed SWATH (HSS).

AM Muzathik et al. (2011). Ocean wave measurement and wave climate prediction of Peninsular Malaysia. Journal of Physical Science, vol 22, 77-92

Wan Aminullah (201). Wave height and wave energy mapping in Malaysian seas using satellite altimetry data. Masters thesis, Universiti Teknologi Malaysia, Faculty of Geoinformation and Real Eastate

Downloads

Published

2021-09-14

How to Cite

Ali, A., & Kai Lun, B. (2021). HYDRODYNAMIC ANALYSIS OF FIN STABILIZER FOR FREEFLOATING SEMI SWATH. Journal of Transport System Engineering, 8(1), 29–35. https://doi.org/10.11113/jtse.v8.150

Issue

Section

Transport System Engineering

Similar Articles

<< < 1 2 

You may also start an advanced similarity search for this article.